I am trying to add a group of ponds to some FS9 scenery. First layer is a Flatten layer. All of the following are VTP2 layers. A basic color layer, followed by another overlay and then the pond layer. All VTP2 layers are on VTP layer 10. If I put a pond outside of the flatten area - it shows fine. I know I am missing something simple but I do not know what.
Also, is there anyway to see a listing of Polys and Lines to check naming? Thanks for any help.
Fred Z.
Fred Zealor
ICAS Air Show Announcer
Adding ponds.
Luis, I am sorry, I gave some bad information. I just checked and the polygons for the small lakes are all LWM Water Masks, which do not have a layer number. I have the Polygon Drawing order set to draw them last. When I first started this project, the small lakes would show up but something got changed and I have no idea what I did.[:I] I keep relearning SBuilder because of the time between uses but really enjoy using it. Thank you VERY much for your work and your help!
Fred Z.
Fred Zealor
ICAS Air Show Announcer
Fred Z.
Fred Zealor
ICAS Air Show Announcer