For Sbuilder for FS9 is it possible to de-select one object if you have many already selected?
I have not found a way and after selecting 20-30 objects I accidently select a wrong object I have to start all over... [:(] Hopefully there is a way?
thx
Possible to DE-select an object of many?
-
- Posts: 8
- Joined: Sat Nov 20, 2004 9:32 pm
- Location: Czech Republic
-
- Posts: 8
- Joined: Sat Nov 20, 2004 9:32 pm
- Location: Czech Republic
Hi,
SBuilder 205 has the "Invert Selection" in the Edit menu.
What Vlada says is this: Say you have 50 objects on your project. Say that 20 of these objects are selected. Say you select the wrong object 21.
You have 21 selected objects and 29 unselected objects. You press the "Invert Selection" tool and you end up with 29 selected objects and 21 unselected objects. Then you select the wrong object. At this stage you get 30 selected and 20 unselected. Then "Invert Selection" again.
You get the original 20 objects selected as desired!
Regards,
Luis
SBuilder 205 has the "Invert Selection" in the Edit menu.
What Vlada says is this: Say you have 50 objects on your project. Say that 20 of these objects are selected. Say you select the wrong object 21.
You have 21 selected objects and 29 unselected objects. You press the "Invert Selection" tool and you end up with 29 selected objects and 21 unselected objects. Then you select the wrong object. At this stage you get 30 selected and 20 unselected. Then "Invert Selection" again.
You get the original 20 objects selected as desired!
Regards,
Luis