General discussion about Scenery Design. Questions about SBuilder for Flight Simulator FS2004.
-
rpa
- Posts: 36
- Joined: Mon Nov 07, 2005 4:14 pm
- Location: Spain
Post
by rpa » Fri Nov 02, 2007 6:03 pm
Hi everybody
I have made with SBuilder the BGL of a high resolution photo scenery and I have added it in FS9. All have gone very well and I can see perfectly the photo scenery in the simulator.
Now, I want to add on this scenery several VTP polygons, textured polygons and a runway. SBuilder works and creates the proper BGLs, but... I can't see the polygons nor runway. Instead, yes... I can see them if I delete the PHOTO.bgl.
It seem that photo scenery covers all the other things.
Please. Can somebody tell me what must I do to see all the other things over the photo scenery?
Thanks.
rpa
-
rhumbaflappy
- Posts: 420
- Joined: Sat Oct 16, 2004 10:11 pm
Post
by rhumbaflappy » Fri Nov 02, 2007 7:30 pm
This hi-res photoscenery is in fact an object. It will show over all terrain or airport surfaces.
Dick
-
Luis Sa
- Posts: 1736
- Joined: Sun May 18, 2003 11:17 am
- Location: Portugal
-
Contact:
Post
by Luis Sa » Fri Nov 02, 2007 11:09 pm
Hi,
Following Dick's note, you can see the runway if you make a hole on the photo.bgl object. Hole=transparent region.
Kind Regards,
Luis
-
rpa
- Posts: 36
- Joined: Mon Nov 07, 2005 4:14 pm
- Location: Spain
Post
by rpa » Sat Nov 03, 2007 9:17 pm
Hi Dick and Luis,
thank you very much for your kindly and rapid response.
I will try to do what both say and then I will see what happens. Still I have many doubts.
Again, thank you very much.
rpa