What must I do?

General discussion about Scenery Design. Questions about SBuilder for Flight Simulator FS2004.
Post Reply
rpa
Posts: 36
Joined: Mon Nov 07, 2005 4:14 pm
Location: Spain

What must I do?

Post by rpa » Fri Nov 02, 2007 6:03 pm

Hi everybody

I have made with SBuilder the BGL of a high resolution photo scenery and I have added it in FS9. All have gone very well and I can see perfectly the photo scenery in the simulator.

Now, I want to add on this scenery several VTP polygons, textured polygons and a runway. SBuilder works and creates the proper BGLs, but... I can't see the polygons nor runway. Instead, yes... I can see them if I delete the PHOTO.bgl.

It seem that photo scenery covers all the other things.

Please. Can somebody tell me what must I do to see all the other things over the photo scenery?

Thanks.

rpa

rhumbaflappy
Posts: 420
Joined: Sat Oct 16, 2004 10:11 pm

Post by rhumbaflappy » Fri Nov 02, 2007 7:30 pm

This hi-res photoscenery is in fact an object. It will show over all terrain or airport surfaces.

Dick

User avatar
Luis Sa
Posts: 1736
Joined: Sun May 18, 2003 11:17 am
Location: Portugal
Contact:

Post by Luis Sa » Fri Nov 02, 2007 11:09 pm

Hi,

Following Dick's note, you can see the runway if you make a hole on the photo.bgl object. Hole=transparent region.

Kind Regards,

Luis

rpa
Posts: 36
Joined: Mon Nov 07, 2005 4:14 pm
Location: Spain

Post by rpa » Sat Nov 03, 2007 9:17 pm

Hi Dick and Luis,

thank you very much for your kindly and rapid response.

I will try to do what both say and then I will see what happens. Still I have many doubts.

Again, thank you very much.

rpa

Post Reply