Mesh does not show.
Posted: Thu Jun 02, 2011 9:21 am
Hi,
I'm making islands in the south of Thailand but mesh from avsim is probably no right, some how too flat or missing.
Look at this picture
http://i205.photobucket.com/albums/bb20 ... /koh-1.jpg
The island on your right is totally flat. In real life there is a hill about 20 m high. I guess the information has been averaged by the sea level around.
There is a big cliff on the near island in the picture. It looks like has been cut by a knief. In real life the hill continue gradually to the shore.
http://i205.photobucket.com/albums/bb20 ... /koh02.jpg
Those small island far from you are totally flat.
I know how to convert HGT to mesh by using S-builder. But I don't know how to modified or correct them. Would you mind telling me how to or where to find tutorial for this. I searched though this web but have no answer.
I did remove the LWM in HPL974280.bgl. So the information from mesh should show up.
Regards,
Tic
I'm making islands in the south of Thailand but mesh from avsim is probably no right, some how too flat or missing.
Look at this picture
http://i205.photobucket.com/albums/bb20 ... /koh-1.jpg
The island on your right is totally flat. In real life there is a hill about 20 m high. I guess the information has been averaged by the sea level around.
There is a big cliff on the near island in the picture. It looks like has been cut by a knief. In real life the hill continue gradually to the shore.
http://i205.photobucket.com/albums/bb20 ... /koh02.jpg
Those small island far from you are totally flat.
I know how to convert HGT to mesh by using S-builder. But I don't know how to modified or correct them. Would you mind telling me how to or where to find tutorial for this. I searched though this web but have no answer.
I did remove the LWM in HPL974280.bgl. So the information from mesh should show up.
Regards,
Tic