Page 1 of 1

Mesh does not show.

Posted: Thu Jun 02, 2011 9:21 am
by jtanabodee
Hi,
I'm making islands in the south of Thailand but mesh from avsim is probably no right, some how too flat or missing.
Look at this picture
http://i205.photobucket.com/albums/bb20 ... /koh-1.jpg

The island on your right is totally flat. In real life there is a hill about 20 m high. I guess the information has been averaged by the sea level around.


There is a big cliff on the near island in the picture. It looks like has been cut by a knief. In real life the hill continue gradually to the shore.
http://i205.photobucket.com/albums/bb20 ... /koh02.jpg

Those small island far from you are totally flat.

I know how to convert HGT to mesh by using S-builder. But I don't know how to modified or correct them. Would you mind telling me how to or where to find tutorial for this. I searched though this web but have no answer.

I did remove the LWM in HPL974280.bgl. So the information from mesh should show up.

Regards,
Tic

Re: Mesh does not show.

Posted: Fri Mar 02, 2012 11:28 am
by Mick
Hi jtanabodee,

your post is somewhat old, but despite not having a tutorial ready I might be able to guide you a little. Are you still engaged with the issue or did you drop or solve it?

Regards
Mick