Change layer for multiple VTP polys?
Change layer for multiple VTP polys?
I am having trouble changing the layer assigned to VTP polys. I can do them individually, I can select multiple polygons, but no matter what I've tried (holding down ctrl while right-clicking, holding down the other ctrl, holding shift, holding both), I can only change properties for a single VTP poly at a time...
Is this possible, and I'm just missing something in the docs, or do I need to do them individually.
Thanks!
sg
(Scott Gridley)
Is this possible, and I'm just missing something in the docs, or do I need to do them individually.
Thanks!
sg
(Scott Gridley)
I'm sure I'm just being dense, but I can't figure it out.
1.) Switch to polygon mode.
2.) Hold CTRL, drag a bog around a bunch of polys.
Now in polygon mode, I can't right click anything or I start drawing polygons.
3.) Switch back to point mode (without letting go of ctrl)
4.) Right-click the line of a polygon, set new value.
5.) Check properties - only that single polygon has the new value, all the others are the same old value...
Any tips a plus!
Thanks,
sg
1.) Switch to polygon mode.
2.) Hold CTRL, drag a bog around a bunch of polys.
Now in polygon mode, I can't right click anything or I start drawing polygons.
3.) Switch back to point mode (without letting go of ctrl)
4.) Right-click the line of a polygon, set new value.
5.) Check properties - only that single polygon has the new value, all the others are the same old value...
Any tips a plus!
Thanks,
sg