Hi,
I'm trying to create some photo scenery for my airport but when I try to compile I get this error:
Error in line 10
-> VTPLayer( 1048581 1 1 0 )
-> value: 1048581 does not fit into instruction
Scasm compilation status: error(s) 1
I'm using version 2.05 of SBuilder and the latest scasm.exe
Scasm error
Hello,
That 1048581 value should be the VTP layer for the phot scenery. If you set it to 4 5 6 or 7 the photo scenery will be applied to land only (clipped by water). If you set it to 8 9 ... it will be applied over water and land. Please check your setting. If you think that everything is fine, you can just make an export of the project and send it to me for verification (do not send the bitmap).
Regards, Luis
That 1048581 value should be the VTP layer for the phot scenery. If you set it to 4 5 6 or 7 the photo scenery will be applied to land only (clipped by water). If you set it to 8 9 ... it will be applied over water and land. Please check your setting. If you think that everything is fine, you can just make an export of the project and send it to me for verification (do not send the bitmap).
Regards, Luis