V2.50 Restore After Save Problem

boleyd · Post by **boleyd** » Tue May 10, 2005 4:16 am

Saved my project which had the mesh map as much larger than the photo map. The mesh map and the photo map had the proper selected areas and occupied the same location at their approximate centers.

Restarted SBuilder and loaded the saved project and received the following presentation. The mesh map is displaced to the left while the two mesh area selections remain where they should be. Also the mesh map is severely reduced in size.

Dick Boley near 5G8

Luis Sa · Post by **Luis Sa** » Tue May 10, 2005 6:28 am

Hi Dick,

This looks like the other problem that you pointed out before. Please use the new oficial release. I hope that is fixed.

Luis

boleyd · Post by **boleyd** » Tue May 10, 2005 8:30 am

Iam using v2.50 EXE dated 5/8/2005.

Dick Boley near 5G8