Problems with textures
Posted: Thu Mar 15, 2007 6:40 pm
I have just started to try some scenery using Sbuilder and have the following problems:
- in VTP2-properties "classes"-textures work ok but "named" and "assembled" make my FS9 crash during terrain loading at about 50%.
I have read the post about the double ;; for "assembled" and corrected the polies.txt manually where necessary.
I tried the same textures in "Texture"-polygon and FS9 loads regular (but these polygon overlay to all others, even Afcad, so I discard them for this time).
When I change my VTP2 to "classes"-textures FS loads normally.
- the other issue is that the VTP2 polies have rough jagged borders, which is disturbing when using textures with clear contrasts (concrete ecc.- BTW I noticed that "Texture"-polies have much clearer borders with the same texture). Is there a possibilty to correct this?
I have version 2.05 revision 6 installed.
Any help welcome.
Thanks, Peter
- in VTP2-properties "classes"-textures work ok but "named" and "assembled" make my FS9 crash during terrain loading at about 50%.
I have read the post about the double ;; for "assembled" and corrected the polies.txt manually where necessary.
I tried the same textures in "Texture"-polygon and FS9 loads regular (but these polygon overlay to all others, even Afcad, so I discard them for this time).
When I change my VTP2 to "classes"-textures FS loads normally.
- the other issue is that the VTP2 polies have rough jagged borders, which is disturbing when using textures with clear contrasts (concrete ecc.- BTW I noticed that "Texture"-polies have much clearer borders with the same texture). Is there a possibilty to correct this?
I have version 2.05 revision 6 installed.
Any help welcome.
Thanks, Peter