While trying to Smooth a polygon I constantly get the following error:
The orange area id the target polygon:
Dick Boley near 5G8
Smoothing Error
G'day Guys,
I use that function all the time. This evening I hunted down & resolved what may have been a similar problem where I had accidentally double clicked & placed two points on the same spot. Once I located the offending point & separated them I was able to successfully smooth the line.
I have found a different problem that if I don't find a solution posted I may do so myself. I have found in my current project where I have a coastline running very close to steep cliffs I am able to see the edge of ground polys showing through my hydro poly. Any idea what to do to fix this apart from drawing another flattening poly inside my shoreline to move the cliffs back a litte?
Regards,
Ross
I use that function all the time. This evening I hunted down & resolved what may have been a similar problem where I had accidentally double clicked & placed two points on the same spot. Once I located the offending point & separated them I was able to successfully smooth the line.
I have found a different problem that if I don't find a solution posted I may do so myself. I have found in my current project where I have a coastline running very close to steep cliffs I am able to see the edge of ground polys showing through my hydro poly. Any idea what to do to fix this apart from drawing another flattening poly inside my shoreline to move the cliffs back a litte?
Regards,
Ross