ESRI Shapefile and Roads
-
- Posts: 3
- Joined: Thu Oct 21, 2010 2:33 pm
ESRI Shapefile and Roads
Hi there, I've imported (appended) an ESRI shapefile which contains Roads (from GeoBase) and this has correctly produced the entire road network as a series of Lines. The problem I have regards road altitude, when importing I set them all to 0m as I don't believe the Geobase data has alititude built into the shapefile data. Will they "drape" themselves over the underlying mesh (which is in a seperate BGL file) or will this be an issue and I also need to therefore set the altitude of each road segment?
- luisfeliztirado
- Posts: 436
- Joined: Sun May 15, 2005 9:15 am
- Location: Santo Domingo
Re: ESRI Shapefile and Roads
Hello Ben,
In FS X, only flattens and hydro polygons (water) have altitudes. Roads and other elements always follow the countour of the relief. So, if you have defined your imported lines as roads, you should have no problem.
Best regards.
Luis
In FS X, only flattens and hydro polygons (water) have altitudes. Roads and other elements always follow the countour of the relief. So, if you have defined your imported lines as roads, you should have no problem.
Best regards.
Luis
-
- Posts: 3
- Joined: Thu Oct 21, 2010 2:33 pm
Re: ESRI Shapefile and Roads
Thanks Luis, just have one other question for now. I have created an exclude polygon changed its type to Exclude_All_Roads but when try to select it along with the roads to compile into a BGL it won't select and when I click on the Info button on the Polygon Properties page it says the type is not described in terrain.cfg?
Edit - Never mind turns out it was being selected but the compiler calls it a Terrain Vector rather than an Exclusion Rectangle. Now off to see if it works!
Edit - Never mind turns out it was being selected but the compiler calls it a Terrain Vector rather than an Exclusion Rectangle. Now off to see if it works!
-
- Posts: 3
- Joined: Thu Oct 21, 2010 2:33 pm
Re: ESRI Shapefile and Roads
Ok that worked well(ish)! The default roads look like they've gone now but a new problem instead, I now have trees all over my runways! It would appear that a exclude designed to exclude roads only does something else too! Anyone have any ideas on how I can fix this?