Water/Blend mask help

This is the Forum to discuss the use of SBuilderX (version 3.10 and above). For previous versions of SBuilder please use the "SBuilder for Flight Simulator FS2004" forum.
Post Reply
TaylorPilot
Posts: 1
Joined: Wed Aug 17, 2011 7:35 pm

Water/Blend mask help

Post by TaylorPilot » Fri Aug 26, 2011 9:17 pm

Hi, I'm Taylor and I'm new to this forum and SBuilderX. I just have a few questions about water/blend masks. I understand what each is, but if I was going to do the airport KMCO (Orlando International airport) with photoscenery, how would I add a blend mask if there is water within the airport grounds? Would I just make a water mask and disregard the need of a blend mask. I know it makes it rather convenient that the airport faces north, so I could do without a blend mask, but what if the airport didn't face north, rather an odd direction making a blend mask necessary?

ananda
Posts: 77
Joined: Thu Jun 25, 2009 8:48 pm

Re: Water/Blend mask help

Post by ananda » Wed Aug 31, 2011 10:12 am

You need a blend mask to remove the photo textures and a water mask to apply water effects.
George

Post Reply