Page 1 of 1

How do you enter and change values in CALIBRATE

Posted: Thu Dec 28, 2017 10:13 am
by jparnold
Hello
I am importing a map from disk and am prompted to CALIBRATE.
The Geo-coordinates displayed are not what I want but I cannot work out what to do to change the values.
Each time I change them and lick the CHANGE 'button' it does not work.
There is a change 'button' on each 'side and I have tried them both.
Is there a trick in how to change them?

Re: How do you enter and change values in CALIBRATE

Posted: Mon Jan 01, 2018 2:20 pm
by luisfeliztirado
Hello,

Perhaps the Calibrate function is a little confusing.

If the Map you import is already calibrated, you will always be prompted to calibrate anyway. You can safely just cancel the calibration as it is not needed.

Best regards.
Luis