How do you enter and change values in CALIBRATE
Posted: Thu Dec 28, 2017 10:13 am
Hello
I am importing a map from disk and am prompted to CALIBRATE.
The Geo-coordinates displayed are not what I want but I cannot work out what to do to change the values.
Each time I change them and lick the CHANGE 'button' it does not work.
There is a change 'button' on each 'side and I have tried them both.
Is there a trick in how to change them?
I am importing a map from disk and am prompted to CALIBRATE.
The Geo-coordinates displayed are not what I want but I cannot work out what to do to change the values.
Each time I change them and lick the CHANGE 'button' it does not work.
There is a change 'button' on each 'side and I have tried them both.
Is there a trick in how to change them?