Hi Luis,
I tried to append a LWM flatten BGL file to my project, but I noticed that there are gaps between the different flatten polygons. Is this something in the data of FS or could it be that SBuilder read them wrong?
As I am trying to export the flattens using the SBX format and then read the information into another tool for processing, I would prefer to have them without gaps.
Arno
LWM Append gaps
Hi Arno,
As you know, LWM polygons should be sliced along LOD13 borders. The gaps you see come from the way SB displays the polygons. Note that the LWM vertices are on a LOD21 grid! You can draw very small polygons but if the points are very closed (more than the LOD21 edge) they will be eliminated.
I would not worry about this. I think SB uses all the available range for LWM coordinates. Play with the "Snap to LOD 21 Grid" to check this.
Regards, Luis
As you know, LWM polygons should be sliced along LOD13 borders. The gaps you see come from the way SB displays the polygons. Note that the LWM vertices are on a LOD21 grid! You can draw very small polygons but if the points are very closed (more than the LOD21 edge) they will be eliminated.
I would not worry about this. I think SB uses all the available range for LWM coordinates. Play with the "Snap to LOD 21 Grid" to check this.
Regards, Luis